Basic Level
- Practical case: Potentiometer as a variable divider
Master Analog Electronics basics by building a variable voltage divider. Use a potentiometer as a variable Resistor to control output signals from 0V to 5V. - Practical case: Series and parallel resistorsMaster Analog Electronics basics by building series and parallel Resistor circuits. Measure equivalent resistance to design precise voltage dividers and loads.
- Practical case: Simple voltage dividerMaster Analog Electronics by building a voltage divider with a Resistor pair. Learn to step down 9V to 4.5V for sensor interfacing and verify the output ratio.
- Practical case: Current limiting in an LEDMaster Analog Electronics basics by building a circuit where a Resistor protects an LED. Apply Ohm’s Law to limit current and ensure safe, steady illumination.
Medium Level
- Practical case: Current measurement with shuntLevel: Medium – Use a very low-value resistor to indirectly measure a DC load’s current via voltage drop.## Objective and use case You will build a direct…
- Practical case: Base Biasing with Resistor
Level: Medium — Calculate and verify a base resistor to switch an NPN transistor safely from a logic output.## Objective and use caseYou will build a… - Practical case: R-2R Resistor Network (Simple DAC)Master Analog Electronics by building a 4-bit DAC using a Resistor ladder. Create precise voltage steps from binary signals for audio synthesis and control.
- Practical case: Unbalanced Wheatstone BridgeMaster Analog Electronics by building a Wheatstone bridge with a Resistor sensor. Measure precise differential voltage changes and calibrate zero-point offsets.
